Menu

Aget Mist Kop Dust Collector

Ref : 1990708-8-MT
Condition : Used
Manufacturer : Aget Mist Kop
Short Description : Dust Collector
Year(s) : -
Quantity : 1
Location : Seller or machines location:
AMERICA North (USA-Canada-Mexico)
Last check : 05 Jul. 2019

11MN51-D1 DUSTKOP
Bag Filter Type
Accepts 45 gal. Drum
1.5 HP - 1.8 Amps/575 Volt, 3 Phase, 60 Cycle Motor
In machining operations, grinding, drilling, and boring operations it will
handle up to three machines in simultaneous operation if they are closely
grouped.
This combination Chip-Mist Collector is designed for use in machining,
drifting, boring, screw machining, and grinding operations where there are
quantities of solid materials mixed with coolants, where a mist collector can
not operate efficiently.
In operation, mist, mixed with chips or moisture laden particles, is sucked
into the Dustkop where the solids are separated from the airstream and then
deposited into a 55 gallon drum. From the Dustkop clean air is forced upward
into the Aget Mist Filter where the moister is separated from the air and the
residual is carried by a tube into a container or one of the sumps of the
equipment.
This combination unit is designed for those operations where chips covered
with oil, wet dust, and other particles of this type are created and are an
air contaminate.
Salvage of waste materials is possible when they are of value, in a 55 gallon
drum which is a standard container and can be replaced at a small cost.

SPECIFICATIONS:
Inlet ..................................... 6"
Spindle Speeds ............................ 3450 RPM
Overall Height ............................ 108"
Diameter .................................. 27-1/2"
Floor Dimensions Height ................... 9,0"
Length ................... 41"
Width .................... 30"
Mist Filter Unit .......................... 27"x36"
Bin Capacity .............................. 7.3 Cubic Feet
Inlet Capacity ............................ 5" or 2 4"
Ratings ................................... 400 To 1000 C.F.M.
Static Pressure Requirements .............. 6.8 W.G.
Horsepower ................................ 1/2
Motor ..................................... 3600 RPM
Volts ............................... 575
Amp ................................. 1.8
RPM ................................. 3450
Base ................................ 3
HP .................................. 1 1/2
HZ .................................. 60
Operating Range ........................... 400 To 900 C.F.M.