Bobst SP 104-E

Sheet size max: 1040x740 mm
Sheet size min.: 400x350 mm
Gripper margin: 1.040+740 mm
Platen pressure max.: 250 t
Production speed: 8500 cycles/h.
Mechanical speed: 8500 sheets/h.

Platform with safety barrier
Centerline system for quick job changeover
Electronic device for sheet travel control
Adjustable centering at the stripping and at the delivery, Air conditioning for the electrical cabinet
Gripper bars
Bobst Electronic System for management of the machine
Main motor with frequency variator
F-9 PRE-SETTING TABLE : Adjustable.
Allows the preparation of a second job during production, reducing machine makeready time and increasing the time available to run production.
Requires: a series of supplementary stripping tools
Pile-tray with handle allowing manual lateral correction of the pile during production
Pile height control at the front edge thanks to a photoelectric cell
Pile rear guide (OS and OOS sides)
Adjustable lateral blowers with Centerline references
Suction unit with multiple adjusting
Safety system for lowering the pile try
C-4 NON-STOP FEEDER MANUAL DEVICE
C-8 VERTICAL POSITIONING OF THE SUCTION UNIT.
Eliminates manual interventions to compensate for the flatness of the pile shape
Covered with an anti-static stainless steel plate
1 Inlet table feeder
4 front lays, adjustable in pairs with front register control
1 Pull-lay operator side (OS) adjustable according to Centerline, with sheet control
1 Double sheet detector, Support plates at entry of platen station
1 Sheet-hold down device (guiding the sheets to front lays)
1 Upper frame with manual lifting device
1 Upper transport equipment for paper, paperboard and corrugated board, 4 Transport belts.
With lateral guidance
C-5 CONTROLLABLE SHEET ARRIVAL FOR PERFECT SYNCHRONIZATION OF SHEET ARRIVAL AND REDUCTION OF MACHINE STOPPAGES
Grippers re-opening device
Die-cutting device without band of gripper grip
Equipment centering and locking
Locking of the chase against the upper beam, Measurement of the die-cutting force with strain gauge
Resocell: synthetic material supporting plate.
Thickness 22.5 mm
1 Upper chase with quick locking: fixed bottom (E-3) Plate, thickness 2 mm and make-ready protection plate of syntetic material
1 mm thickness, E-5 COMPENSATION PLATE 4 mm thickness.
it's useful for thin plate for repetetive work

E 55 ADJUSTABLE SUPPORTING PLATE CENTERINGS : micromeric screws allow fine adjustment of counters mounted on the cutting plate with respect to the die (+/- 0,9 mm lengthwise and crosswise.
3 drawer frame system
1 Upper Stripping Frame (F-2)
1 Upper stripping equipment (F-21) required to create a waste stripping tool, including crossbars,
clamps, stripper holders and stripping pins of 3, 5 and 10 mm of diameter
1 Fastening equipment for stripping die (F-22)
1 lower pull-out frame (F-8)
1 Lower stripping equipment (F-81) Equipment for waste stripping including crossbars, pins and supports
F-31 1 UPPER PULL-OUT FRAME QUICK LOCK.
It reduces stripping tool assembly times; the quick-closing device allows the tool to be changed in the machine)
F-72 1 CENTRAL PULL-OUT FRAME QUICK LOCK
>Pile tray in delivery, Adjustable rear and side joggers with Centerline marks, 1 Braking brush
Pneumatically controlled adjustable front joggers
G-5 AUTOMATIC NON-STOP ON DELIVERY
Operator safety devices
Gripper Bar Chain Slip Clutch
Gripper bar chain locking device
Handling of the diecutting equipment, Emergency Stops