Bobst SP 76 BM

N.of Impressions 49 mio.
N.of working hours 24985
Electronic device for sheet travel control
Air conditioning for the electrical cabinet
Gripper bars
C.U.B.E. Bobst-electronic for managing the machine
C.U.B.E. Bobst-electronic for managing the complementary equipment BM
Main motor

Feeder
Pile-tray with handle allowing manual lateral correction of the pile during production
SPECIAL SHEET BREAKER DEVICE. To push the sheets downwards, ensuring good stacking
NON-STOP FEEDER MANUAL DEVICE
Adjustable lateral blowers with Centerline references
Suction unit with multiple adjusting
Safety system for lowering the pile try
KERSTEN ANTISTATIC DEVICE ON THE SHEET FEEDER FOR SHEET TRAVEL

Introduction table
Covered by antistatic steel stainless plate
Sheet synchronization adjustable during the machine is running for adapting feeder cycle to platin cycle
4 front lays, adjustable in pairs with front register control
Pull lay operator side adjustable according to Centerline marks, with side rgister control
"Double sheet" detector
Sheet-hold down device (guiding the sheets to front lays)
Upper frame with manual lifting device
Upper transport equipment for paper, paperboard
Transport mat. With lateral guidance

Platin
Heated upper platen with 12 heating zones
Grippers re-opening device
Equipment centering and locking
Locking of the chase against the upper beam
Measurement of the die-cutting force using an electronic probe
Synthetic material supporting plate. Thickness 15 mm
Compensating plate, thickness 2,3 mm
Compensating plate, thickness 4 mm. It is used as a cutting plate for die cutting
Honeycomb frame. Includes a series of cliché fixing accessories. To specify: height of the clichés
COMPENSATING PLATE, THICKNESS 2,3 MM. 1 unit with the basic machine

Delivery
Pile tray
Braking Brush
Pneumatically controlled adjustable front joggers
AUTOMATIC NON-STOP BELT. The belt automatically enters on delivery when the pile
of sheets is complete. Facilitates the use of non-stop by eliminating the manipulation of the grid. This mat replaces the Non-stop grille (Standard)
Pneumatically controlled adjustable lateral and front joggers with Centerline marks

Supplementary equipment "BM"
3 shafts for adjusting the advancement of the belts driven by motors
3 reel-holder boards
6 reel holders 3"
6 reel holders 1"
10 drive rollers
1 automatic device for putting the platen "on and off" pressure
1 Margin line. Facilitates the positioning of clichés
1 blower with nozzles to detach the belts after printing (mounted on the platen)
1 blower inside the platen to stabilize the sheets of paper before printing or die-cutting (mounted on the platen)
1 belts guide on the upper post (mounted on the platen)
1 belt tension shaft driven by a motor (mounted on the platen)
1 bands break control system with 8 photo-electric cells with lateral adjustment for immediate machine stop in case of band breakage
1 lateral evacuation device for metal band with rotary brushes at variable speed depending on the advancement of the belts (mounted on the platen)
1 longitudinal belts cutting device (mounted on the platen)

Security:
Operator safety devices
Gripper Bar Chain Slip Clutch
Handling of the diecutting equipment
Emergency Stops