Cyril Bath V-20 20 Tons

CYRIL BATH CNC HORIZONTAL STRETCH WRAP FORMING PRESS
Model V-20
Mfg. 2003

TWO SET OPPOSING JAWS (TWIN TENSION JAWS)
SHALLOW ARK.
SINGLE PLANE

DISTANCE BETWEEN PRIMARY JAWS:
Minimum 140" (3,556mm)
Maximum 168" (4,267.2mm)

DISTANCE BETWEEN SECONDARY JAWS:
Minimum 68.5" (1,7399mm)
Maximum 92.5" (2,349.5mm)

TENSION CYLINDER PULL:
Maximum Pull 20 Tons
Stroke 12" (304.8mm)

ARM SWING ANGLE: Die stays constant to table.
Stretch and wrapping around die
Forward 10 Degrees Back 35 Degrees
Total 45 Degrees

SWING ARM: Extended 75⅜" (1,914,53mm)
Retracted 49-11/16" (1,26206mm)

DIE TABLE: 3 Posts
Working Surface, Width overall 102½" (2,603.5mm)
Distance between two Front Posts centers 57½" (1,460.5mm)
Distance center of two Die Post and Rear Post Die (each side) 35" (889mm)

MOTOR DRIVE: Wired 440 volts, 3-phase
Hydraulic Pump 100 H.P. 230/460 volts
Cooler Fan Motor 5 H.P. 230/460 volts
Oiler Cooler Fan 1½ H.P. 208 / 230 volts
CONTROLS: Window 2000 Operators Interface, QNX Machine Controls.
Power Supply. Hard Drive , 101 Keyboard. Color CRT.

REMOTE CONTROL STATION:
Power On/Off Buttons. Hydraulic On/Off Button.
Lamp Test Button. Emergency Stop and Reset Buttons.
Mode Selector Switch: Length / Manual / Auto.
Load Adjustment Dials. Right and Left Arm Back / Wrap Toggle.
Right and Left Tension Cylinder In / Out Toggle.
Left and Right Long Jaw Open / Close Switch.
Left and Right Short Jaw Open / Close Switch.

COMPLETE FACTORY SAFETY GUARDS
Overall Width 239"(6,070.6mm),
Front to Back 89⅜" (2,270.13mm), Height 76" (1,905mm)
Weight 25,000 lbs
Approximate Total Weight 32,000 lbs.