Marquip 1.850 mm Synchro Sheeter + 6 unwind stands

SYNCHRO SHEETER + UNWIND STANDS FOR 6 WEBS
The machine installation comprises of the following equipment.
The sheeter was made in 2016

UNWIND STAND
1850mm Marquip V Double sided stands x 3 units
For up to 6 reels when paper thickness is considered.
Max Roll Width 1850mm; Min Roll Width 450mm
Max Roll Diameter 1830mm; Min Roll Diameter 470mm
Max Roll Weight 3410 Kgs
Torque Activated Step Chucks 76 – 152mm (3 to 6”) per roll 6 units
Unwind Web Clamp 6 units
Manual Reel Trolley Low Profile 6 units
Roll Diameter Sensing Web Tension Control – Single Web - 6 units
Motorised Roll/Edge Decurler 1900mm 6 unis
Overhead Web Support Rolls
Web Aligner for 6 webs
Operators Side Platform
Back Stop Catwalk

Tidland Class III Manual Setup
Digital Readout System for Assisted Anvil Positioning 1
Trim Removal Nozzles – Mounted to Slide with Clamps 1
Trim Removal Fingers with Air Assisted Trim Deflectors 1
Cuttinghead – 1850mm Dual Rotary Knife (Synchro Sheeter)
Cut length Accuracy +/- 0.4mm
Knife Loading 1000 GSM Under knife
Machine Max Speed - 300 MPM
Practical Production Speeds are a function of material basis weight, stiffness, surface finish,
caliper, consistency, sheet size, number of webs at a time, environmental conditions, general machine conditions, knowledge of operator..
Cut Quality depends on paper thickness, coatings and knife set up for optimum cut.
Multi Web of up to 700mm in total of 6 reels.
Squareness 0.06mm of the sheet width.
Moisture Content 5 to 8%
Splice detectors and Auto Reject gate
First and overlap conveyors with Vacuum Box for high speed sheet control and overlapping.
Pile up (Jam) Detectors at strategic locations on the sheeter
Tapes Over Stack for pile control
Semi Auto Pallet Changer
Tab Inserter – 3 units
Line Control Software with Backup Copy
Sheeter General Specification:
Operating Temperature Range 5 to 40 Degree C (41 to 105 degree F)
Relative Humidity 20 to 95%