Nissei FN460-160A 501 T

CLAMP UNIT
Clamp force: 501 U.S. Tons
Molding clamp stroke 1025 mm (40.35”)
Minimum mold thickness 375 mm (14.76”)
Maximum daylight opening1400 mm (55.12”)
Clearance between Tie Bars (HxV): 820 mm x 820 mm (32.28″ x 32.28″)
Die plate dimensions (HxV): 1190 mm x 1190 mm (46.85″ x 46.85″)
Ejector stroke: 160 mm (6.30”)

INJECTION UNIT
Screw diameter: 80 mm (3.15″-B)
Shot size 53.90 oz. G.P.P.S.
Injection Pressure 22396 PSI
Screw speed 0-120 RPM Constant torque
120-180 RPM Variable torque

ELECTRICAL UNIT
Pump motor kW 75 HP
Primary voltage/phase/cycle 575/3/60
Heater voltage/phase/cycle 230/3/60
Control circuit 24volt DC
Heater voltage requires separate 230volt supply

Customer must supply:
ISOLATION (NOT AUTO) transformer for stability of power and for filtering electrical noise
All other electrical connections as required

GENERAL
Hydraulic oil required: 1310 litres

FEATURES
With TACT controller, 80 mm hardened barrel and screw
(2) Hydraulic corepull
(1) Air core pull
Air blow off circuit
Non-insulated barrel cover
Cycle counter
Centralized manual lubrication system
Screw cold start preventing circuit
Hydraulic oil temperature upper and lower limit warnings
Water saver valve, Mounting pads
Optional Tecnomagnete Magentic Platens