Standard Modern Engine Lathe 2000 RPM 1660

STANDARD MODERN LATHE1660

Swing 16"
Swing Over Cross Slide 10"
Centers 40"
Spindle Bore 2.06"
RPM 2,000 RPM
Power 10 hp
Dimensions R-L 88" X F-B 48" X Height 60"
Weight 2800 Lbs.

EQUIPPED WITH
Electric brake - self actuating
All hardened gears - no clutches
Direct reading speed dial
Deep bed design
Full length rear splash guard
Hardened quill with tang drive
Convenient Hi-Lo neutral shifter
inch and metric threads
Feed reverse
Leadscrew reverse
Chip clean out - front and rear
Bi-direction auto carriage stop (feeds and threads)
Combination Inch-metric dials

SPEC SHEET
Machine
Swing Over Bed Ways 17"
Swing Over Cross Slide 10"
Center Distance 60"
HEADSTOCK
Spindle speeds 18
Geometric speed range 40-2000 RPM
Spindle nose - camlock D1-6
Spindle hole 2.06” (52.4 mm)
Chuck Size 12" 4- Jaw (New Gator with 2-piece jaws)
Chuck Size 10" 3-Jaw (New Gator with 2-piece jaws)
FEEDBOX - COMBINATION
Feed & thread selections 66
Inch feed range .0015- .105 in./rev.
Inch thread range 2 to 127 TPI
Metric feed range .04 to 2.67 mm/rev.
Metric lead range (threads) .2 to 14 mm
APRON
Handwheel - one revolution 1.000 in. (25.4 mm)
Half nuts Double
High speed threading to 800 RPM
Repeatability of auto carriage stop +/- .005 in. (+/- .13 mm
CARRIAGE CROSS-SLIDE
Carriage length on bed 18.25 in. (465 mm)
Carriage bridge width 8.5 in. (215 mm)
Cross-slide length 20 in. (508 mm)
Cross-slide travel 8.5 in. (215 mm)
Compound travel 3.8 in. (96 mm)
Direct reading dial graduation .001 in. (.02 mm)
TAILSTOCK
Quill diameter 2.44 in. (62 mm)
Quill travel 5 in. (127 mm)
Morse taper with tang #4 M.T
Offset +/- .75 in. (+/- 19 mm)
Main Motor 10 Hp. 220 / Amps 25 /440 15 Amps / 3 / 60 Cycle
Floor Space 48" X 108"
Machine Height 60"
Machine Weight 3,050 Lbs.
Steady Rest 12"Roller Type Yes
Taper Attachment Yes
Coolant And Chip Pan Yes
Back Splash Guard Yes